Training courses - PU encapsulated strain gauges

The following courses are available  and can be tailored to specific applications. The modules are  for 2/3 people per session, lasting approximately 1-3 days.  Each person trained will receive comprehensive, hands on experience, being guided through each step of the process.

Module 1. Installation of GF PU-encapsulated gauges using Cyanoacrylate adhesives. Module 1 instructs you in the following areas:
Surface preparation (using power tools where appropriate)
Alignment & marking
Strain gauge installation Inspection & test
Inspection & test
Protective coating
Module 2. Installation of GF PU-encapsulated gauges using room temperature cure epoxy adhesives.  Module 2 follows the same format as Module 1 but includes:Strain gauge installation including clamping methods.
Module 3. Installation of  Weldable strain gaugesModule 3 follows the same format as module 1 but includes:Strain gauge installation using a low energy spot welder.
Module 4.  Installation of HT encapsulated strain gauges to hot substrates (120°C to 270°C ).
Module 4 follows the same format at module 1.
Module 5. Installation of standard strain gauges using Cyanoacrylate adhesive. Module 5 follows the same format at module 1.
Module 6. Installation of standard strain gauges using Room temperature cure epoxy adhesive. Module 6 follows the same format at module 2.
Module 7. Soldering techniques. ½ day  training course covering Basic soldering & wiring techniques for inter-gauge wiring.